Foamed rubber has a cohesive structure, so it can work both as an insulator and as an absorber. At the same time, due to the closed surface on the outside, it does not absorb moisture, is very elastic, absolutely DOES NOT burn, and has an excellent waterproof adhesive layer. Application areas: floor, trunk, wheel arches outside, hood, special. equipment. - sealing material for various connections, joints, seams, including rubbing car panels (molded car parts, parts of plastic panels); - cushioning (anti-creaking) between plastic and metal parts. Directions for use To obtain the best results in reducing vehicle noise, it is recommended to install the material on a vibration-damping layer. The product can be easily mounted on surfaces of complex geometry. The products are mounted on clean, dry surfaces. Preparation for installation If the product is stored or transported at a temperature below 0 °C, before use, it is kept at a temperature of (20±5) °C for at least 24 hours. The temperature of the workroom where installation is carried out must be at least 15 °C.The mounting surface is first cleaned of dust and dirt; if it is heavily contaminated with oil, it is degreased with technical solvents and left until completely dry. Installation The product is released from the anti-adhesive substrate evenly without jerking and carefully pressed to the surface, avoiding the formation of air bubbles and pulling out of the material. Installation on contaminated and corroded metal surfaces is not allowed.